12
To meet the applicable safety provisions, only the tool/protector combinations as
indicated in the table must be used.
Be sure to use genuine MAKITA cutter blades or nylon cutting head.
- The cutter blade must be well polished, free of cracks or breakage. If the cutter
blade hits against a stone during operation, stop the engine and check the blade
immediately.
- Polish or replace the cutter blade every three hours of operation.
- If the nylon cutting head hits against a stone during operation, stop the engine and
check the nylon cutting head immediately.
- Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
- When using the string head, fit the protector (6) into the protector (1), and tighten
them with two nuts (5) and two screws (4).
MOUNTING OF PROTECTOR
To Next Page
Loading...
