Bedpan / Urinal Bottle and Utensil / Bowl Washer Disinfector (WDS)
Operation, Maintenance and Installation Manual
Issue 16 Page 25 August 22
4.1 Detergent Warnings
First Warning
When last full segment is showing, ‘LOW DETERGENT’ will flash (there is approx. 1.5 to 1.6 litres in bottle)
Second Warning
When no full segments are showing ‘EMPTY DETERGENT’ will flash, there is approximately 750mL to 1litre in bottle
Third warning
Fault 302 - detergent time out (no detergent in bottle)
When full bottle is installed the detergent line will require purging (see 5.7)
FAULT 302
4.2 Fault Indication
In the event of a failure during cycle the device will go into fault. The display will show the selected cycle the device was
operating in when the failure occurred along with a fault code corresponding to the cause of the fault. Access to the load
will not be allowed until the cause of the fault has been fixed and a cycle has been successfully completed. Please refer to
the Fault Codes section of this manual for a description of the fault code displayed.
FLT XXX flashing
Audible Buzzer will beep
After fault has been rectified a Purge/Reset will be required to reset the device (see
5.9). On completion of the “Purge Reset” device will restart previous cycle and will
not allow access to the load until cycle has been successfully completed.
To Next Page
Loading...
