Bedpan / Urinal Bottle and Utensil / Bowl Washer Disinfector (WDS)
Operation, Maintenance and Installation Manual
Issue 16 Page 5 August 22
1.2 Detergent
WARNING!
SAFETY GLOVES AND GOGGLES MUST BE WORN WHEN CHANGING
DETERGENT AND DISPOSING OF EMPTY CONTAINERS
Current Safety Data Sheet for Malmet detergent is available in .PDF format from Malmet’s website.
www.malmet.com.au
Changing the Detergent Bottle
The 5 litre detergent container is accessed by opening the bottom door. Only use Malmet approved detergent (See
technical data for detergent details)
1. Pull handle on detergent door and open
2. Unscrew cap and pull out with suction hose (let hose hang in detergent chamber)
3. Remove empty bottle and replace with full bottle
Note: Leave cap on new bottle until in position
4. Remove cap on new bottle and fit existing hose and cap, make sure suction hose is at bottom of bottle
5. Close detergent door
6. Restart device operation as normal
7. Check fill level indicator on display. Should show as
Note: Do not drop detergent container onto base plate. This may result in damaging the load cell.
Disposal of Empty Detergent Bottles
1. When handling empty containers treat as though container is full and wear appropriate PPE as per MSD
requirements
2. Triple rinse container and puncture base to render unusable
3. Dispose of containers as per facility chemical waste handling procedures, and/or local government requirements
To Next Page
Loading...
