Using the system
44
1.
From the Naming and positioning section, select Range.
2.
Specify both the First position (where the sampling commences) and the Last pos-
ition (where the sampling ends).
Note: using this method, vials must be placed in the plate in sequence - it is
not possible to sample from non-contiguous vials using this function - instead
the Load from file option should be used.
Vials are analyzed by row, then column. Ensure the location of your vials in the trays
corresponds to that entered in the SOP Player. Sampling begins with the tray and vial
indicated as the First position and completes on the tray and vial Last position. For
example if you only wished to sample from Tray 1, and had loaded it with 10 vials in this
pattern (A1-B2):
To Next Page
Loading...
