Maintenance & Troubleshooti ng
52
Waste tubing
The following connections for disposal of waste liquids are made:
l
General waste: connect the drain tubing (in the installation kit of the Nan-
oSampler) to the left-hand drain hose connector (see System configuration on
page 25). Place the other end in a waste bottle on the floor. This is used to drain
all liquid dispensed to the wash position. Sample liquid that is not injected is also
removed through this tubing.
l
Condensation water and leakage drain: leaked solvents and condensation
(from cooling) are drained through the right-hand hose connector (see System
configuration on page 24).
Ensure that none of the drain or waste tubes are twisted as this might obstruct the flow
path.
To Next Page
Loading...
