Maintenance & Troubleshooti ng
53
Replacing fuses
If you need to replace the fuses, ensure that you install fuses of the same type and rating.
Fuses are located in the fusebox at the back of the NanoSampler (see System con-
figuration on page 24). Fuses of the following types are installed in the NanoSampler:
l
Fuse type:2 x 2.5AT, 250V, 1500A
Warning: switch off and disconnect the NanoSampler from its power source by
removing the mains power cord before replacing fuses.
To Next Page
Loading...
