Maintenance and Care
MAN Industrial Diesel Engines D2848/40/42 LE201/203/211/213
56
Carefully read the Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
Change oil filter elements - on dual horizontal oil filters
NOTE!
Use a container with sufficient ca
pacity to change oil (at least 10
litres). This ensures that oil will not
overflow.
1. Remove oil drain screw (1) from oil filter bowl
(2) and completely drain engine oil.
2. Loosen mounting bolt (3) of filter bowl (2) .
3. Remove filter bowl (2) along with filter element
(4).
4. Remove filter element (4) from filter bowl (2).
5. Clean filter bowl(2).
6. Insert new filter element (4) and install filter
bowl (2) with new seal (5).
7. Insert and tighten mounting bolt (3) of filter bowl
(2).
Tightening torque 50 Nm.......................
8. Install oil screw (1) with a new sealing ring and
tighten.
Tightening torque 40 Nm.......................
The second filter element is changed in the same
way.
12
3
4 5
To Next Page
Loading...
