M&R Challenger 2 - Page 30

V.033114
30 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Mega-Stamp
Down Time
Mega-Stamp
Manual Test
Down Time is used to select the amount of time
that the Mega-Stamp heat platen is down in
contact with the foil and garment. To adjust the
Down Time, press the data entry cell to the right;
a numeric keypad is displayed. Enter the down
time and then press Enter. Your selection for the
Down Time is displayed in the data entry cell.
Manual Test is used to confirm communication
between the press and the Mega-Stamp unit. To
use, press the OFF button to the right of Manual
Test. The Mega-Stamp heat platen cycles down
and the button indicates On.
Midas Loader
Midas-Loader
Enabled
Disabled
Midas
Head Location
Midas
Manual Test
The Midas Loader menu selection is used to
control the optional M&R Midas foil loader.
To activate the Midas, press the Disabled button
to the right of MIDAS-LOADER. The indication
changes to Enabled and the Midas is activated.
To deactivate the Midas, press the button again.
Head Location is used to select the print head in
which the M&R Midas will operate. To use, press
the data entry cell to the right of Head Location; a
numeric keypad is displayed. Enter the print head
location where the Midas will be operating and
then press Enter.
Manual Test is used to confirm the
communication between the press and the Midas
unit. Press the OFF button to the right of Manual
Test. The Midas foil gripper cycles in/out and the
button indicates ON.
Press the Forward Arrow to access the next
Mega-Stamp menu screen.
Mega-Stamp/
Midas
This screen visually confirms the operation of the
switches used to control the Mega-Stamp and the
Midas. The screen shows the input signals (green)
and the output signals (red) and whether they are
ON or OFF.
The first menu is Both Safe. This menu is
displayed in green so it is an input signal. The
illustration shows the input signal as OFF.