To access the Alarms screen, press the Alarms
button on the Menu screen.
If an alarm condition is detected from the previous
production run or production day, the Alarm
indication (alarm bell) appears in the upper right
corner of the display window. This condition alerts
the operator that an Alarm condition exists, and
that operation of the system is not possible.
To determine the cause of the Alarm condition
press the Alarms button or the alarm bell and the
Alarms screen will direct you to the area in the
system where the Alarm condition exists. For
example, if the red Emergency Stop button has
been activated, or left in the ON position at the
conclusion of the previous production shift, the
Alarms screen alerts the system operator by
displaying Emergency panel.
Deactivate the Emergency Stop button and press
the green RESET push button to resume
operation and clear the Alarms message.
Press the Back Arrow to return to the previous
screen. Should there be any additional alarm
conditions, these will also be displayed on the
Alarms screen.
The Service Data screen is intended for use by
M&R Authorized Service Personnel Only and
requires the use of a password for access.
DO NOT ATTEMPT TO ACCESS THE SERVICE
DATA MENU!
The Service Data screen is also used to access
the Date/Time, Clean, Video and Utility screens.
To Next Page
Loading...
Need help?
General
