LIMIT TRANSPORTAION MODE / WORKING MODE
Arms rested and telescope lowering.
The extension arm can raise or lower in area
of transportation with a lower telescope.
Return of the telescope inferior at 2 cm.
INSTALLATION AND LIFTING
The access platform is designed to work on flat, horizontal ground. It is important to clear enough space for the access
platform to work in.
- Move the access platform into its working area.
- If necessary, load the equipment to be carried. store this so that it does not impede the user, and to prevent any falls.
- Climb into the access platform.
You must wear a safety helmet for this operation.
During maneuvres of the access platform (raise, rotate, etc, ...), keep looking above and about you. Watch out in parti-
cular for electric cables and any other objects that may be located in the volume in which the access platform moving.
LOWERING
When the work has been completed, lower the telescope and the arm, returning the machine to the transportation
position.
Watch out carefully for people on the ground when lowering the access platform
STOPPING OF THE ACCESS PLATFORM
When the access platform is not use, cut off the electrical power supply with a general switch.
At the end of the day, re-charge the battery if necessary (see chapter "MAINTENANCE PERIODICITY").
2 - 23
< 2 cm
Lift to the max. to 5 cm
To Next Page
Loading...
