18
DORADO COMP 37MM SERVICE GUIDE
8
9
Install the top cap onto the end of the compression
rod. Use a 16 notch Bottom Bracket Tool and a 13mm
wrench to tighten to the proper torque of
3.4-4.5 N m (30-40 in lb). Add 30-40cc of semi bath
into the outer leg.
Install top cap into the outerleg. Using a 16 notch
bottom bracket tool tigthen to 6.8-9Nm
{60-80 In-Lb}.
SPRING LEG ASSEMBLY
Using the sag guide tool to spread the crowns, slide the leg into the crown, align to proper wheel size
and tighten crown bolts to 10.7-12.4 Nm {95-110 In-Lb}.
10
To Next Page
Loading...
