Manitou DORADO COMP - Damping Leg Service Assembly

10
DORADO COMP 37MM SERVICE GUIDE
1
2
3
Inspect the inner and outer damper tubes and be sure they
are free from debris and contaminants. Put a small amount
of Slickoleum Grease on the O-ring on the rebound end of
the damper cartridge assembly. Install the assembly in the
inner leg by sliding it into the bottom of the leg. Use a 26mm
socket to tighten it into the leg. Tighten to 6.8-9 Nm
(60-80 in lb).
Insert the detent springs into opposite holes in the end cap
and place the detent balls on top of the springs. To hold the
detent balls in place on the spring use a small dab of grease.
DAMPING LEG ASSEMBLY
Install the ABS+ adjuster knob onto the end cap and secure
with the 2mm screw.