19
DORADO COMP 37MM SERVICE GUIDE
DUST & OIL SEAL REPLACEMENT
1
Using a pick or small blade screwdriver remove the
wear ring from the outer leg.
2
3
Gently pry out the old dust seal from the outer leg. A
tool we have found that works well is a
downhill tire lever. If using a flat blade screwdriver to
remove the seal be careful the tip of the blade does not
catch on the lip inside the outer leg.
Remove the foam ring. Clean seal bore and bushing thouroughly.
4
Soak new foam in Manitou bath oil. Place foam ring in the bottom of the seal bore.
To Next Page
Loading...
