Manitou DORADO COMP - Damping Leg Service Disassembly

6
DORADO COMP 37MM SERVICE GUIDE
1
Be sure you capture the 2 detent balls and
springs under the knob
First step is to loosen the damping leg top cap using a
16 notch Bottom Bracket Tool. It helps if the leg is still
clamped in the lower crown assembly while breaking
the top cap loose (be sure the upper crown is loosened,
you only want the lower tightened when breaking loose
the top cap). Only loosen the top cap at this point. Do
not remove it.
2
3
DAMPING LEG DISASSEMBLY
Using a 2mm Allen wrench, remove the ABS+ adjuster
knob Be sure you capture the 2 detent balls and
springs under the knob
NOTE: Be sure to hold the knob still while removing
the screw. The damper adjuster may be damaged
if the knob is over torqued.