Manitou DORADO COMP - Page 7

7
DORADO COMP 37MM SERVICE GUIDE
4
Remove the top cap from the fork leg using a 16 notch Bottom Bracket Tool. The top cap is still attached
to the rebound shaft at this point.
5
6
You will now remove the top cap from the rebound
shaft. Place a 13mm wrench on the flats of the rebound
shaft and use a 16 notch Bottom Bracket Tool to
unthread the top cap from the shaft. Once the top cap
is unthreaded, remove the rebound knob from the top
cap.
Loosen the pinch bolts on the lower crown and remove the damping leg from the fork. You will need to remove the frame
bumpers to do so. Put them in a safe place so you do not misplace them.
TIP: The ends of the Dorado sag guide can be used to spread the clamps apart and aid in leg removal.
Remove the fork leg from the bike stand and pour the
oil out of the leg. Slide the inner leg out of the outer leg
and leave the outer leg to drain in a drainage pan.
Clamp the upper sleeve of the fork in bike stand.
DAMPING LEG DISASSEMBLY
7
8