Manitou DORADO PRO - Page 11

11
DORADO PRO 37MM SERVICE GUIDE
4
5
6
Holding the damper end-cap up-right using Manitou
Clamp Blocks in vise (or lightly clamped in soft-jaw
vise) position the notch
on the HSC compression adjuster slightly up.
Fill M5x0.8 Luer lock syringe with 5wt Damper oil
(85-0023). Remove bleed-screw from damper end-cap
and attach the filled syringe M5x.8 adapter to end-cap
bleed port.
Simultaneously compress the filled syringe and retract
the empty syringe to remove air from the damper.
Refill the syringe as needed until oil is drawn into the
damper upper syringe.
PRO DAMPER SERVICE