3
25
MHT 10120 L M
Series
E
E
5
5 - EMPTYING AND CLEANING THE FUEL TANK.
During this operation, do not smoke and do
not approach with naked lights
Place the truck on a horizontal surface; the engine must be
stopped.
- Make a visual and manual check on the parts on the fuel cir-
cuit and in the tank which may leak.
- In case of leaks, contact your agent or dealer.
Never attempt to make a weld or perform any other
operation on your own: this might cause an explosion
or a fire.
- Place a container under the drainage cap “1” (Fig. E5/2) and
unscrew it.
- Remove the cap “1” (Fig. E5/1).
- Allow all the fuel to drain out and rinse with 10 litres of clean
fuel, poured into the filler orifice.
- Replace and tighten the drainage cap “1” (Fig. E5/2).
- Fill the tank with clean fuel filtered through a suction rose or a
clean cloth that does not leave residue; then refit the filler
plug “1” (Fig. E5/1).
- Start the thermic motor and let it run to the minimum for a few
minutes, before using the truck at maximum speed.
E
E
6
6 - CHECK THE WEAR OF THE JIB PADS
For this oparations, consult your agent or dealer.
FIG. E5/1
FIG. E5/2
1
1
To Next Page
Loading...
Need help?
General