2
17
MHT 10120 L M
Series
1
1
0
0
-
-
WINDSCREEN-WASHING LIQUID TANK
On the operator’s left. Remove the cap “A”; make sure that
the tank is always full.
Liquid to be used: water + window-cleaning detergent (use
an anti-freeze in winter).
1
1
1
1
-
-
ACCELERATOR PEDAL, SERVICE BRAKE AND
INCHING PEDAL
Pedal “B” can be used to vary the speed of the fork-lift truck by
adjusting the engine rpm.
Pedal “C” acts on the front brakes and can be used to slow down
and stop the truck. During the first 20 mm of its stroke, the brake
pedal acts as an inching pedal, allowing precise, slow movements;
in the rest of its stroke, it produces the braking effect.
1
1
2
2
-
-
DIRECTION REVERSER LEVER
The truck’s travel direction must be reversed at low speed
and without accelerating.
FORWARD TRAVEL: Raise the lever slightly and push it
forward (Position A).
REVERSE: Raise the lever slightly and pull it back (Position B).
NEUTRAL : When the truck is started, the lever must be in
neutral (Position C).
N.B.: The reverse travel lights indicate that the truck is travelling in reverse.
There is also a reverse warning beeper.
If the gear does not engage forwards or backwards, see point “5B” on page 14.
These instructions must be complied with to allow the transmission to operate correctly.
C
A
B
BC
A
To Next Page
Loading...
Need help?
General