3-14
SERVICING SCHEDULE
(1): MANDATORY 500 HOUR OR 6 MONTH SERVICE
This service must be carried out after approximately the first 500 hours of operation or within the 6 months following the start-up of the machine (whichever
occurs first).
(*): Every 10 hours during the first 50 hours, then once at 250 hours.
(**): Consult your dealer.
A = ADJUST, C = CHECK, G = GREASE, N = CLEAN,
P = BLEED, R = REPLACE, V = DRAIN
PAGE
(1)
DAILY OR EVERY 10
HOURS SERVICE
EVERY 50 HOURS
SERVICE
EVERY 250 HOURS
SERVICE
EVERY 500 HOURS
SERVICE OR 6
MONTHS
EVERY 1000 HOURS
SERVICE OR 1 YEAR
EVERY 2000 HOURS
SERVICE OR 2 YEARS
EVERY 4000 HOURS
SERVICE
OCCASIONALLY
I.C. ENGINE
I.C. engine oil level
3-16 C C <<< <<< <<< <<< <<< <<<
Cooling liquid level
3-16 C C <<< <<< <<< <<< <<< <<<
Fuel level
3-16 C C <<< <<< <<< <<< <<< <<<
Fuel pre-filter
3-17 C C <<< <<< <<< <<< <<< <<<
Cyclonic pre-filter
3-17 N N <<< <<< <<< <<< <<< <<<
Dry air filter cartridge
3-20/35 C/N C/N <<< R <<< <<< <<<
Radiator cores
3-20 N N <<< <<< <<< <<< <<<
Condenser core (OPTION Air conditioning)
3-20 C/N C/N <<< <<< <<< <<< <<<
Alternator/ fan/ crankshaft belt tension
3-30 C/A C/A <<< <<< <<< <<<
Compressor belt tension (OPTION Air conditioning)
3-30 C/A C/A <<< <<< <<< <<<
I.C. engine oil
3-34 V V <<< <<< <<<
I.C. engine oil filter
3-34 R R <<< <<< <<<
Fuel pre-filter
3-35 R R <<< <<< <<<
Fuel filter
3-36 R R <<< <<< <<<
Fuel tank
3-40 N <<< <<<
Safety dry air filter cartridge
3-40 R <<< <<<
I.C. engine silent blocks
C** <<< <<<
I.C. engine rates
C** <<< <<<
Valves clearances
C** C** <<< <<<
Cooling liquid
3-46 V <<<
Radiator
C** <<<
Water pump and the thermostat
C** <<<
Alternator and the starter motor
C** <<<
Turbocompressor
C** <<<
Fuel system
3-48 P
TRANSMISSION
Gear box oil level
3-17 C C <<< <<< <<< <<< <<< <<<
Transmission universal joint
3-21 G G <<< <<< <<< <<< G/C**
Gear box oil filter
3-36 R R <<< <<< <<<
Gear box oil
3-41 V V <<< <<<
Gear box sump strainer
3-41 N <<< <<<
Silentblocks in the gear box
C** <<< <<<
Gear box controls
C** <<< <<<
Gear box pressures
C** <<<
Converter pressure
C** <<<
TYRES
Tyre pressure
3-18 C C <<< <<< <<< <<< <<< <<<
Wheel nut torque
3-18 C C <<< <<< <<< <<< <<< <<<
Condition of wheels and tyres
C** <<< <<<
Wheel
3-49 R
MAST
Tension and alignment of the mast lifting chains
3-21 C/A C/A <<< <<< <<< <<< <<<
Mast
3-22 G G <<< <<< <<< <<< <<<
Mast uprights
3-30 N/G* <<< <<< <<< <<<
Mast lifting chains
3-37 N/C/G N/C/G <<< C* <<<
Condition of mast unit
C** <<<
Chain rollers
C** <<<
Mast guide rollers
C** <<<
Mast bearing rollers
C** <<<
Thickness of the mast wearing plates
C** <<<
HYDRAULIC
Hydraulic oil level
3-25 C C <<< <<< <<< <<< <<<
Hydraulic return oil filter cartridge
3-37 R R <<< <<< <<<
Hydraulic oil
3-43 V <<< <<<
Suction strainer for hydraulic oil tank
3-43 N <<< <<<
Filter cap for hydraulic oil tank
3-43 R <<< <<<
Speeds of hydraulic movements
C** <<< <<<
Hydraulic pump tubular filter
N** <<< <<<
Condition of hoses and flexible pipes
C** <<< <<<
Condition of cylinders (leakage, shafts)
C** <<< <<<
Hydraulic circuit pressures
C** <<<
Hydraulic circuit outputs
C** <<<
Hydraulic oil tank
N** <<<
647003 EN (03/01/2012)
To Next Page
Loading...
Need help?
General