Manitou ME 425 C 48V S3 User Manual

WITH CENTRAL FILLING
- Raise the battery cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Disconnect the battery plug (1).
- The level indicators (3) must be in the up position.
- If necessary, top up with clean distilled or demineralized water.
- Connect the pipe (4) to the pipe of the pump (5).
NOTE: The pump must be situated at a higher level than the battery.
- When the correct level is reached, the vanes (6) automatically stop turning.
- Disconnect the hose (4).
- Check the terminal connections and lightly smear with petroleum jelly to prevent
the formation of verdigris.
- Reconnect the battery plug (1).
- Close the battery cover.

IMPORTANT

Handling and servicing a battery can be dangerous, take the following precautions:
- Wear protective goggles, gloves, an apron and acid-resistant clothing.
- Remove rings, watches, bracelets and any clothing incorporating metal.
- Keep the battery horizontal.
- Never smoke or work near a naked flame.
- Work in a well-ventilated area.
- Wash your hands each time you work on the battery, as acid is corrosive.
- In the event of electrolyte being spilled onto the skin or splashed in the eyes, rinse thoroughly with cold water for
15minutes and call a doctor.
A3 – CLEANING THE BATTERY
CHECK

IMPORTANT

Disconnect the battery plug and protect before washing.
The battery must be kept clean and dry at all times to avoid self-discharge and leakage
currents.
- Raise the battery cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
WASHING
- Check that the caps are firmly closed.
- Clean the water with soft, non-pressurized water.
- Allow to dry in the open air and wipe the top of the battery with a clean cloth.
NOTE: After washing with water, part of the washing water will have entered the
battery tray and must therefore be drained.
DRAINING THE BATTERY TRAY
- Connect the pipe (1) to the tube (2).
- Fill the bulb (3) and connect it to the other end of the pipe (1).
- Place a container near to the battery. This container must be placed below the bottom of the tray.
- Once the pipe (1) is filled, remove the bulb (3) and place the end of pipe (1) over the container.

IMPORTANT

Handling and servicing a battery can be dangerous, take the following precautions:
- Wear protective goggles, gloves, an apron and acid-resistant clothing.
- Remove rings, watches, bracelets and any clothing incorporating metal.
- Keep the battery horizontal.
- Never smoke or work near a naked flame.
- Work in a well-ventilated area.
- Wash your hands each time you work on the battery, as acid is corrosive.
In the event of electrolyte being spilled onto the skin or splashed in the eyes, rinse thoroughly with cold water for 15 minutes and call a doctor.
3-11
2
3
1
3
3
3
3
3
3
3
3
4
6
5
647503 (10/05/2017)
M
E 418/420/425C 48V S3

Manitou ME 425 C 48V S3 Specifications

General

Brand	Manitou
Model	ME 425 C 48V S3
Category	Forklifts
Language	English