Manitowoc Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI - Control Logic and Touchpad Matrix

Operation Section 3
3-10
Part Number 020003315 1/11
Control Logic Matrix
System power on
(24V from transformer)
Energize
Touchpad (active)
Touchpad LEDs (sync w/other touchpad)
y
LCD Display
= 2
LCD Display
= 1
Brand or Flavor?
Flavor
Brand
Carb/Non-Carb Mode (Brand only)
Cont. LED - carbonated
Flash LED (0.5s on/off) - plain
Tap touchpad to switch
Dispense Time Mode (Flavor only)
Cont. LED - 1s dispense
Flash LED (0.5s on/off) - 2s dispense
Tap touchpad to switch
LCD Display
= 0
n
Brix Mode
Fixed 1.6s dispense
Brand = syrup and
Flavor = F1 = C1, F2 = C2, F3 = NC2
F5 = C4, F6 = C3, F7 = NC3
Tap touchpad to activate
Normal Dispense Mode
Brand - ON MODE - Water on then Syrup on 60 ms later.
OFF MODE - Syrup off then Water off 60 ms later.
Flavor shot - 1s or 2s (release and press - no delay between dispenses)
LED Sequence Mode
Touch brand button location shown below to change
1. LED flash outside to center (0.5s on/off) Default (S1 and S16)
2. LED flash center to outside (0.5s on/off) (S2 and S15)
)41S dna 3S()ffo/no s5.0( lla hsalf DEL .3
)31
S
dna 4S(suou
n
i
t
noc DEL .4
)1
1S
d
na 5
S(t
hgi
r
o
t
tfel
re
s
ahc D
E
L .5
)21S dna 6S(tfel ot thgir resahc DEL .6
)01S dna 7S(lla ffo DEL .7
LCD Display
= 3
Program Mode?
Prog button
pressed > 3s?
n
Prog button
pressed > 3s or
300s elapsed?
y
n
y
y
n
Prog button
pressed > 3s or
300s elapsed?
Prog button
pressed > 3s or
300s elapsed?