OPERATING CONTROLS AND PROCEDURES RT765E-2 OPERATOR MANUAL
3-42 Published 4-09-2021, Control # 364-11
4. Fully retract the boom and position it in the normal travel
position.
5. Engage the swing brake and/or swing lock pin.
6. Retract all jack cylinders and outrigger beams.
7. Apply the parking brake.
8. Put all operating controls in the neutral position.
9. Position the Crane Function switch to OFF.
10. Shut down the engine following the proper procedures
specified in this Handbook and the applicable Engine
manual.
11. Remove the keys.
12. Close and lock all windows, covers, and doors.
13. Turn Battery Disconnect to OFF position (shown) if
machine will be inactive for over 24 hours (Figure 3-22).
Unattended Crane
The configuration in which the crane should be left while
unattended shall be determined by a qualified, designated
individual familiar with the job site, configuration, conditions,
and limitations.
CAUTION
Avoid Crane Damage!
Do not engage the park brake while the vehicle is moving.
Damage to the crane can occur.
Disengage the park brake before driving. Damage to the
crane can occur.
CAUTION
Risk of Undesirable Operation!
To avoid possible engine fault codes and undesirable
operation, ensure the keyswitch has been off two minutes
before disconnecting the batteries.
Disconnect batteries, if machine will be inactive for over
24 hours.
DANGER
Tipping Hazard!
Changing weather conditions including but not limited to:
wind, ice accumulation, precipitation, flooding, lightning,
etc. should be considered when determining the location
and configuration of a crane when it is to be left
unattended.
Failure to comply with these instructions may cause death
or serious injury.
To Next Page
Loading...
Need help?
General
