What to do if my Manitowoc Broiler has delayed ignition?
If your Manitowoc Broiler experiences delayed ignition, it could be due to several reasons. First, the unit might be over-gassed fired, in which case you should adjust the manifold pressure. Second, the injector could be incorrect, so verify the injector size. Finally, the burner ports might be plugged; if so, clean the burner ports.
Why do flames lift off the burners on my Manitowoc GT Broiler?
If the flames lift off the burners in your Manitowoc Broiler, it indicates that too much air is mixing with the gas. To resolve this, reduce the air shutter opening.
How to fix a soft, lazy, yellow burner flame on a Manitowoc GT?
If the burner flame on your Manitowoc Broiler is soft with a lazy, yellow tip, it means not enough air is mixing with the gas. You can fix this by opening the air shutter.
What to do if the pilot burner will not ignite on my Manitowoc GT Broiler?
If the pilot burner on your Manitowoc Broiler will not ignite, there are a couple of potential causes. The pilot flame might be too small, in which case you should adjust the pilot valve. Alternatively, there might be a draft in the kitchen; determine the cause of the draft.
Why does the flame lift off the pilot on my Manitowoc GT?
If the flame lifts off the pilot on your Manitowoc Broiler, it indicates that the pilot is over-gassed fired. Adjust the pilot valve to correct this.
Critical warnings regarding potential hazards during installation, operation, or maintenance of the equipment.
Key instructions and advice to ensure proper use and understanding of the service manual.
Details on the location and purpose of the equipment's rating plate.
Explanation of the serial number format and its components for identification.
Procedure for lighting standing pilot lights on all Garland/US Range appliance models.
Pilot lighting and shutdown procedures for Griddles with SIT Thermostats.
Pilot lighting and shutdown procedures for Griddles with GS Thermostats.
General procedure for safely shutting down the appliance.
Specific shutdown steps for Griddles equipped with SIT Thermostats.
Location and adjustment of pilot adjustment valves on Open Top Burners.
Procedure for adjusting the burner gas and air shutter for optimal flame.
Overview of the two igniter systems used on Garland griddle units.
Procedure for removing and replacing the Electronic Spark Generator unit.
Instructions for adjusting the pilot flame on SIT Thermostat controlled griddles.
Mandatory steps for validating the SIT thermostat's performance in the field.
Procedure for calibrating the GS Thermostat on griddle units.
Step-by-step instructions for replacing a GS Thermostat on the griddle.
Procedure for adjusting the low flame setting on Hi/Lo valves.
Procedure for adjusting the burner gas and air shutter on griddles.
Procedure for adjusting the burner gas and air shutter on broiler units.
To Next Page
General