OPERATOR MANUAL
This manual has been prepared for and is considered part of the
NBT40-1 Series Cranes and Aerial Lifts
This Manual is divided into the following sections:
SECTION 1 INTRODUCTION
SECTION 2 SAFETY PRECAUTIONS - CRANE
SECTION 3 SAFETY PRECAUTIONS - AERIAL LIFT
SECTION 4 OPERATING CONTROLS - CRANE
SECTION 5 OPERATING CONTROLS - AERIAL LIFT
SECTION 6 EQUIPMENT SET-UP
SECTION 7 LUBRICATION
SECTION 8 MAINTENANCE CHECKLIST - CRANE
SECTION 9 MAINTENANCE CHECKLIST - AERIAL LIFT
SECTION 10 SPECIFICATIONS
SECTION 11 SAFETY DECALS
NOTICE
The equipment serial number is the only method your distributor or the
factory has of providing you with correct parts and service information.
The equipment serial number is identified on the builder’s decal attached
to the right side of the turret. Always furnish equipment serial number
when ordering parts or communicating service problems with your
distributor or the factory.
An untrained operator subjects himself and others to death or
serious injury. Do not operate this equipment unless:
• You are trained in the safe operation of this equipment. Manitowoc is
not responsible for qualifying personnel.
• You read, understand, and follow the safety and operating
recommendations contained in the equipment manufacturer’s
manuals and load charts, your employer’s work rules, and applicable
government regulations.
• You are sure that all safety signs, guards, and other safety features are
in place and in proper condition.
• The Operator Manual and Load Chart/Reach Diagram are in the
holder provided on the equipment.
DANGER
3-29-2018 Control # 610-00
© 2018 Grove U.S. L.L.C.
To Next Page
Loading...
Need help?
General
