64 Part Number 8001119 10/19
Step 7 Mix a solution of cleaner and warm water.
Depending on the amount of mineral buildup, a larger
quantity of solution may be required. Use the ratio in
the table below to mix enough solution to thoroughly
clean all parts.
Step 8 Use half of the cleaner/water solution to clean
all components. The cleaner solution will foam when it
contacts lime scale and mineral deposits; once the
foaming stops use a soft bristle brush, sponge or cloth
(not a wire brush) to carefully clean the parts. Soak the
parts for 5 minutes (15 – 20 minutes for heavily scaled
parts). Rinse all components with clean water.
Step 9 While components are soaking, use half of the
cleaner/water solution to clean all foodzone surfaces
of the ice machine and bin. Use a nylon brush or cloth
to thoroughly clean the following ice machine areas:
• Evaporator plastic parts – including top, bottom
and sides
• Bin bottom, sides and top
Rinse all areas thoroughly with clean water.
Step 10 Mix a solution of sanitizer and warm water.
Step 11 Use half of the sanitizer/water solution to
sanitize all removed components. Use a cloth or
sponge to liberally apply the solution to all surfaces of
the removed parts or soak the removed parts in the
sanitizer/water solution. Do not rinse parts after
sanitizing.
Solution Type Water Mixed with
Cleaner 4L. (1 gal)
500 ml (16 oz)
cleaner
Solution
Type
Water Mixed With
Sanitizer 23 L. (6 gal )
120 ml
(4 ounces) sanitizer
To Next Page
Loading...
Need help?
General