96 Part Number 8001119 10/19
Delay Start
Pressing the “Delay Start” button will initiate a delay
cycle. The ice machine will not run until the delay time
expires.
• Pressing the button once will energize the 2 hour
light and initiate a two hour delay period.
• Pressing the button a second time will energize the
4 hour light and initiate a four hour delay period.
• Pressing the button a third time will energize the 8
hour light and initiate an eight hour delay period.
• Pressing the button a fourth time will cancel the
delay cycle.
REPEAT DELAY PERIOD EVERY 24 HOURS
1. Press power button to stop the ice machine.
2. Press the delay button - The power LED will
energize and the 2 hour delay LED will blink 3
seconds on and 1/2 second off to indicate a 2
hour delay is in effect every 24 hours.
3. Pressing the delay button again will energize the
4 hour light and initiate a four hour delay period
every 24 hours.
4. Pressing the delay button again will energize the
8 hour light and initiate an eight hour delay period
every 24 hours.
5. Pressing the delay button again will cancel the 24
hour repeat delay. Start with step 1 to reenter 24
hour delay setup.
EXAMPLE
Setting a daily 4 hour delay from 1 pm to 5 pm.
At 1 pm perform steps1 through 3 above. The 4 hour
delay light will blink every 3 seconds to indicate it is in
a delay period. After 5 pm the ice machine will fill the
bin as needed. At 1 pm on all following days the ice
machine will initiate a delay period at 1 pm and flash
the 4 hour delay LED.
Canceling a 24 hour delay period
Press the power button while a delay period is active
or follow delay start steps or disconnect/reconnect the
power supply.
To Next Page
Loading...
Need help?
General