Mantall XE80C - Page 26

Operator’s Manual
Self-Propelled Scissor Lift
Version1
26
Test Limited Drive Speed
45. Type A/B controller: press the lift function enable button. Indicator light must be on.
46. Press and hold the function enable switch on the control handle.
47. Slowly push the control handle forward and raise the platform more than 5 ft (1,5 m) from its
stowed position.
➢ Result: The pothole guards should deploy.
48. Type A/B controller: press the drive function enable button. Indicator light must be on.
49. Press and hold the function enable switch on the control handle.
50. Slowly push the control handle to the full drive (forward or backward) position.
➢ Result: The maximum achievable drive speed with the platform raised should not exceed
0.64 ft/s (0,7 km/h).
WARNING
If the drive speed with the platform raised exceeds 0.64 ft/s (0,7 km/h), immediately tag and
remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground using the platform controller. Do not stand in the platform.
51. Type A/B controller: press the lift function enable button. Indicator light must be on.
52. Press and hold the function enable switch on the control handle.
53. Slowly pull the control handle backward and completely lower the platform.
54. Place a 2x4 or similar piece of wood in front of the both wheels on one side.
55. Type A/B controller: press the drive function enable button. Indicator light must be on.
56. Press and hold the function enable switch on the control handle.
57. Slowly push the control handle forward and drive the machine onto the pieces of wood.
58. Type A/B controller: press the lift function enable button. Indicator light must be on.
59. Press and hold the function enable switch on the control handle.
60. Slowly push the control handle forward and raise the platform.
➢ Result: When the platform is raised 5 ft (1,5 m) from its stowed position, an alarm should sound
and platform raise is stopped. Drive function should not operate. Tilt indicator light on the
platform controller should flash.
61. Pull the control handle backward and completely lower the platform.
62. Drive the machine off the pieces of wood and remove them.