Do not sit, stand or climb on the platform guard rails. Maintain a firm footing on the platform floor at all
times.
Do not climb down from the platform when raised.
Keep the platform floor clear of debris.
Lower the entry bar or close the entry gate before operating.
Do not operate the machine unless the guard rails are properly installed and the entry is secured for
operation.
3.2.5 Collision Hazards
Do not operate the machine with the chassis trays open.
Be aware of limited sight distance and blind spots when driving or operating.
Be aware of extended platform position when moving the machine.
Machine must be on level surface or secured before releasing brakes.
Operators must comply with employer, job site and governmental rules regarding use of personal
protective equipment.
It is recommended that operators wear an approved helmet when operating the machine.
Check work area for overhead obstructions or other possible hazards.
Be aware of crushing hazard when grasping the platform guard rail.
To Next Page
Loading...
