Do Not Operate Unless:
• You learn and practice the principles of safe machine operation contained in this
Operator’s Manual.
1. Avoid hazardous situations.
2. Always perform a pre-operation inspection.
3. Always perform function tests prior to use.
4. Inspect the workplace.
5. Only use the machine as it was intended.
7.1 Fundamentals
o The Operating Instructions section provides instructions for each aspect of machine operation. It is
the operator's responsibility to follow all the safety rules and instructions in the Operator's Manual.
o Using the machine for anything other than lifting personnel and tools to an aerial work site is unsafe
and dangerous.
o Only trained and authorized personnel should be permitted to operate a machine. If more than one
operator is expected to use a machine at different times in the same work shift, they must all be
qualified operators and are all expected to follow all safety rules and instructions in the Operator's
Manual. This means that every new operator should perform a pre-operation inspection, function
tests, and a work place inspection before using the machine.
7.2 Emergency Stop
Push in the Emergency Stop button of the ground control panel or platform controller to the OFF position to
stop all functions.
Repair any function that operates when either Emergency Stop button is pushed in.
Push in and pull out the Emergency Stop button of the ground control panel or the platform controller to
reset the system.
7.3 Emergency Lowering
In the event of a power failure, pull the manual lowering knob located at the back of the chassis to
manually lower the platform.
To Next Page
Loading...