Manusa Optima+ - Page 14

Installation manual I Manusa
D01230EN-v4
142. Commissioning
Workflow:
This menu defines the second function of the key [T1] (3-sec hold):
By default, a *60% reduction opening is defined.
This can be set between 1 and 9, whereby 1 represents 10% and 9
represents 90%. The digits [x - y] are shown on the screen;
x = menu and y = the percentage of reduction opening (flashing).
Menu 1: Reduction opening
1
1.1 Opening [1-9]
Menu 2: Internal detection
2
80% reduction
opening
*60% reduction
opening
40% reduction
opening
This menu defines the sensitivity of the internal detection sensor.
Short internal detection. Menu 2.1:
Sensitivity of sensor to microwaves deactivated.
The display shows the following graphic intermittently until you confirm.
Normal internal detection. Menu 2.2:
Normal sensitivity of sensor to microwaves.
The display shows the following graphic intermittently until you confirm.
Long internal detection. Menu 2.3 (default):
Maximum sensitivity of sensor to microwaves. This is the default factory
setting. .
The display shows the following graphic intermittently until you confirm.
2.1 Short
2.2 Normal
2.3 Long
Menu 3: External detection
3
3.1 Short
3.2 Normal
3.3 Long
This menu defines the sensitivity of the external detection sensor.
Short external detection. Menu 3.1:
Sensitivity of sensor to microwaves deactivated. The presence sensor is used
for the opening operation.
The display shows the following graphic intermittently until you confirm
.
Normal external detection. Menu 3.2:
Normal sensitivity of sensor to microwaves.
The display shows the following graphic intermittently until you confirm.
Long external detection. Menu 3.3 (default):
Maximum sensitivity of sensor to microwaves. This is the default factory
setting .
The display shows the following graphic intermittently until you confirm.