o
Dynamic Compression
Compress dynamic range (difference between loud and soft sounds).
Auto:
Automatic dynamic range compression
on/off control according to source.
Low / Medium / High: These set the compression level.
Off: Dynamic range compression is always off.
0
“Dynamic Compression” can be set when Dolby Digital, Dolby Digital Plus,
Dolby TrueHD or Dolby Atmos signal is input.
0
The default setting is “Off”. When the input signal is the Dolby TrueHD or
Dolby Atmos source, the default setting is “Auto”.
0
This can be set when “Loudness Management” is set to “On”.
o
Low Frequency Effects
Adjust the low frequency effects level (LFE).
n
When “Input Mode” is set other than to “7.1CH IN”
-10 dB – 0 dB (Default : 0 dB)
n
When “Input Mode” is set to “7.1CH IN”
0 dB / +5 dB / +10 dB / +15 dB (Default: +10 dB)
For proper playback of the different sources, we recommend setting to the
values below.
0
Dolby Digital sources : 0 dB
0
DTS movie sources : 0 dB
0
DTS music sources: -10 dB
Contents Connections Playback Settings Tips Appendix
191
Front panel Display Rear panel Remote Index
To Next Page
Loading...
