TV Format
Set the video signal format to be output for the TV you are using.
o
Format
NTSC
(Default):
Select NTSC output.
PAL: Select PAL output.
“Format” can also be set by the following procedure. However, the menu screen
is not displayed. Following the display content to make the setting.
1. Press and hold the main unit’s STATUS and ZONE SELECT at the same time
for at least 3 seconds.
“zVideo Format <NTSC>” appears on the display.
2.
Use the main unit’s o or p and set the video signal format.
3. Press the main unit’s ENTER to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the picture
will not be displayed properly.
Contents Connections Playback Settings Tips Appendix
217
Front panel Display Rear panel Remote Index
To Next Page
Loading...
