Marantz Model 30 - Setting Remote Control Codes for the Remote Control; Setting Remote Control Codes for the Main Unit

Setting remote control codes for the
remote control
o
To set the remote control codes to AMP1,
AMP2 or AMP3
1
Hold down i and one of the number 1, 2 or 3 buttons
for more than 5 seconds.
0
Set the remote control code to AMP1, AMP2 or AMP3 according
to the selected number button.
NOTE
0
The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Setting remote control codes for the
main unit
1
Point the remote control for which the remote control
code was set at the main unit, and press i and ENTER.
When setting the remote control code of the main unit is complete,
the remote control code set (AMP 1 – 3) is displayed on the display.
Contents Connections Playback Settings Tips Appendix
32
Front panel Rear panel
Remote control
unit
Index