Marantz NR1609 - Page 128

3-3. Operation Info Mode
3-3.1. Actions
This mode enables the unit to display the accumulated operating time, power On count and each pro-
tection count.
3-3.2. Starting up
While holding down buttons "
ZONE2 SOURCE
" and "
STATUS
" simultaneously, press the power button
to turn on the power.
Select the "
4. OP INFO
" using the "
INTERNET RADIO
" button, then press the "
STATUS
" button then to
conrm.
3-3.3. Operations
Press the "
STATUS
" button after starting up this device in Operation Info mode.
The following information is displayed in the following order.
(1) Accumulated operating time
OP Time ______H
"
STATUS
" ↑ Time display
(2) Power On count
P.On Time______
"
STATUS
" ↑ Count display
(3) DC / ASO Protection count
DC:___/ASO:___
"
STATUS
"
(4) Thermal Protection (A/B) count
THM A:___/B:___
"
STATUS
"
(5) Thermal Protection (E) count
THM E:___
"
STATUS
"
(6) Current Protection count
Current:___
"
STATUS
"
(Returns to normal display)
3-4. TUNER STEP mode (U / N only)
3-4.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3-4.2. Starting up
While holding down buttons "
ZONE2 SOURCE
" and "
STATUS
" simultaneously, press the power button
to turn on the power.
Select the "
5. TUNER FRQ SET
" using the "
INTERNET RADIO
" button, then press the "
STATUS
" but-
ton then to conrm.
3-4.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "
INTERNET RADIO
" button,
then enter using the "
STATUS
" button.
The following information is displayed in the following order.
(1) AM9 kHz / FM50 kHz is selected
< AM9/FM50 >
"
INTERNET RADIO
" "
ZONE2 SOURCE
"
(2) AM10 kHz / FM200 kHz is selected
< AM10/FM200 >
"
STATUS
"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
128