Connecting and playing back from a
computer (USB-DAC)
You can enjoy high-quality audio playback from the D/A converter built in
to this unit by inputting PCM signal or DSD signal music files into this unit
from a computer via USB connection.
0
Before USB connecting this unit to your computer, install the driver
software in your computer.
0
Drivers do not need to be installed for Mac OS.
0
Also, you can use whichever commercially available or downloadable
player software you like to playback files on your computer.
o
Computer (recommended system)
OS
0
Windows
®
Vista, Windows 7 or Windows 8
0
Mac OS X 10.6.3 or later
USB
0
USB 2.0: USB High speed/USB Audio Class Ver.2.0
0
DSD is a registered trademark.
0
Microsoft, Windows Vista, Windows 7 and Windows 8 are either
registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
0
Apple, Macintosh and Mac OS are trademarks of Apple Inc.,
registered in the U.S. and other countries.
o
Installing the dedicated driver
(Windows OS only)
n
Installing the driver software
1
Disconnect the USB cable between your PC and the
unit.
0
The driver software cannot be installed correctly if your PC is
connected to the unit by a USB cable.
0
If the unit and your computer are connected by a USB cable and
the computer is switched on before installation, disconnect the
USB and restart the computer.
2
Download the dedicated driver from the “Download”
section of the PM7005 page of the Marantz website
onto your PC.
3
Unzip the downloaded file, select the 32-bit or 64-bit
exe file that matches your Windows operating system,
and double-click the file.
Contents Connections Playback
Settings
Tips Appendix
30
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
