Connect and playback from a digital
device (Coaxial/Optical)
1
Connect digital device to this unit. (v p. 22)
2
Press the input source select button (COAXIAL or
OPTICAL) to switch the input source to “COAXIAL” or
“OPTICAL”.
3
Start playback of the digital device connected to this
unit.
The COAXIAL or OPTICAL input indicator flashes if this unit cannot
detect the sampling frequency of the input signal.
4
Press VOLUME df to adjust the volume.
o
Files that can be played back
See “D/A converter” (v p. 47).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0
If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
Recording
Audio signals input into this unit can be output to an external recording
device. When recording audio from a playback device connected to this
unit, audio can be recorded with the playback device still connected to this
unit.
1
Press X on this unit to turn the power on.
2
Press the input source select button to switch to the
input source from which you want to record.
The indicator of the selected input source lights.
3
Recording starts.
0
For information on operations, see the owner’s manual of the
recording device.
Contents Connections Playback
Settings
Tips Appendix
37
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
