Why does my Marantz Stereo Receiver display “ANTENNA”?
If your Marantz Stereo Receiver displays “ANTENNA”, it indicates that the XM terminal and the XM Connect-and- Play antenna are not properly connected. Check that the connections are correct.
General| Channels | 7.1 |
|---|---|
| Dolby Digital | Yes |
| DTS | Yes |
| Frequency Response | 10 Hz - 100 kHz (+1, -3 dB) |
| Signal to Noise Ratio | 105 dB |
| Speaker Load Impedance | 6-8 ohms |
| Video Connections | Component, Composite, S-Video |
| Input Impedance | 47 kohms |
| Power Output | 80W (8 ohms, 20 Hz - 20 kHz, THD 0.08%) |
| Tuning Range | FM, AM |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200 mV |
| Speaker Impedance | 8 ohms |
| Dimensions | 440 x 151 x 370mm (W x H x D) |
To Next Page
