To Next PageTo Next PageWhy does my Marantz Stereo Receiver display “ANTENNA”?
If your Marantz Stereo Receiver displays “ANTENNA”, it indicates that the XM terminal and the XM Connect-and- Play antenna are not properly connected. Check that the connections are correct.
General| Channels | 7.1 |
|---|---|
| Dolby Digital | Yes |
| DTS | Yes |
| Frequency Response | 10 Hz - 100 kHz (+1, -3 dB) |
| Signal to Noise Ratio | 105 dB |
| Speaker Load Impedance | 6-8 ohms |
| Video Connections | Component, Composite, S-Video |
| Input Impedance | 47 kohms |
| Power Output | 80W (8 ohms, 20 Hz - 20 kHz, THD 0.08%) |
| Tuning Range | FM, AM |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200 mV |
| Speaker Impedance | 8 ohms |
| Dimensions | 440 x 151 x 370mm (W x H x D) |
Specifications for the FM tuner, including frequency range, sensitivity, signal-to-noise ratio, and distortion.
Procedure for aligning idling current in the power amplifier section using a voltmeter.
How to enter and navigate the service mode for checking firmware and display segments.
Steps to reset the backup memory to default status, clearing EEPROM.
Displays shown on the FLD when the microprocessor detects a trouble.
Guidelines for replacing the microprocessor or Flash ROM and managing software.
