Marantz UD9004/U1B - Ajusting the Position of the Loader Panel

16
UD9004
AJUSTING THE POSITION OF THE LOADER PANEL
Perform this adjustment when repairing for uneven gaps around the loader panel (top, bottom, left and right) and when re-
mounting mechanisms removed when making repairs.
<Preparations>
･
First turn on the power, open and close the tray once, then turn the power off.
･ Check the various actual gaps.
･ Loose the screws marked d and b fixing the mechanism in place.
1.Adjusting the gaps
1.1. Adjusting the left and right gaps
(1) With the mechanism pressing against the front, adjust so that there is no gap on the left and right.
1.2. Adjustingthetopandbottomgaps
(1) Using a hexagonal wrench, turn the screws marked ★ on the left and right to adjust the top and bottom gaps of the left
and right trays.
(When it turns to clockwise, the opening above spreads.)
(2) Fasten the mechanism using the two screws marked d.
(3) Fasten the mechanism using the two screws marked b.
2.Final check
After completing the operations, turn on the power and open and close the tray once to check the gap.
ً
ً
View RView L
Detail of View L
Detail of View R