Install two D Cell batteries. Check the door of the battery compartment for correct
battery position.
- Open the hot water on a nearby faucet. Confirm proper water flow through the unit
and out of the faucet. (You should hear a "clicking" sound from the unit. This is the
ignitor activating). Turn the water back off.
- Start the gas supply. Check again for gas leaks using soapy water and correct as
necessary.
- Open the hot water faucet. You should hear the ignition clicking, and hot water
should begin flowing. Sometimes, if there is air in either the water or gas supply lines,
you will not get immediate combustion. If this is the case, turn the water on and off
several times to clear the water and gas lines of any air pockets that may be present.
- All water heaters have a seasonal summer/winter switch to meet your water
temperature needs. This is because extra heating may be required when incoming
water temperatures are lower (winter), and less heating is required when incoming
water temperatures are higher (summer). Use the summer setting when incoming
water temperatures are a little higher. Use the winter setting when incoming
water temperatures are a little lower.
- When the water supply is turned off, the water heater will stop working. When you
turn the water back on, the water heater will reignite. Please note that if you use the
hot water multiple times in quick succession, the water may be excessively hot for
one or two seconds. Please wait for the temperature to adjust before using.
- If you close the water inlet valve or the water outlet valve, the water heater will shut
off immediately. Shut off the gas supply after use.
OPERATING INSTRUCTIONS
Specification
Sighting window
Winter/Summer knob
Gas controlling knob
DRAWING 05
H D
Instruction
L
13
To Next Page
Loading...
Need help?
General
