PACKING LIST
1. WATER HEATER - QTY 1
2. OPERATING INSTRUCTIONS - QTY 1
3. MOUNTING SCREWS - 4 SETS
- You MUST install this water heater according to all directions and specifications
contained in this manual. Failure to properly install the heater can result in property
damage or severe injury or death by burning, explosion, or asphyxiation due to
carbon monoxide. Neither manufacturer nor brand are responsible for any property
or personal damages.
- You MUST check the exhaust flue for obstructions at the initial installation and at
least annually thereafter.
- You MUST check all connections for gas leaks with soapy water before firing the
unit. This must be done at the initial install and after every propane bottle change if
using an LP model. If you detect a gas leak of any kind, DO NOT fire up your unit.
- You MUST check for gas leaks by smell. Understand that LP is heavier than air and
may sink to ground level. If you detect a gas leak of any kind, DO NOT fire up your unit.
- You MUST observe the unit in operation for several cycles before leaving it unattended.
- Unit MUST be hung vertically, with the water and gas connections at the bottom
and the exhaust at the top. Unit must be properly vented according to instructions
in this manual.
- You MUST use a carbon monoxide detector in conjunction with this, or any, gas
burning appliance.
- Do NOT expose the water heater to strong wind (including that from fans) or rain.
- Do NOT install the water heater near flammable or volatile substances. Do not
handle or store these substances near the heater (gasoline, acetone, motor oil, paint
thinners or any other flammable or volatile substance).
- Do NOT use tubing or piping that is aging or cracked in any way.
- Do NOT use this appliance with any type of gas other than that indicated on the
data plate located on the side of the unit. Death or severe injury may result.
IMPORTANT WARNINGS
05
To Next Page
Loading...
Need help?
General
