5
Nº326S Preamplifier Phono Modules Installation Instructions & Release Notes
Installation The following materials are needed to install the phono modules:
Instructions
Item Quantity
Nº326S Preamplifier 1
Nº326S phono modules 2
Anti-static wrist strap 1
1/8-inch hex-key 1
Flat-blade screwdriver 1
Note
The phono modules must be configured BEFORE installation.
WARNING
THESE SERVICE INSTRUCTIONS ARE ONLY INTENDED
FOR USE BY QUALIFIED PERSONNEL. DO NOT PER-
FORM ANY SERVICING UNLESS QUALIFIED TO DO SO.
REFER TO THE IMPORTANT SAFETY INSTRUCTIONS
(PAGE ii) PRIOR TO PERFORMING ANY SERVICE.
CAUTION
• NEVER MAKE OR BREAK CONNECTIONS TO THE
Nº326S UNLESS IT AND ALL ASSOCIATED
COMPONENTS ARE POWERED OFF AND
DISCONNECTED FROM ELECTRICAL OUTLETS.
• DISCONNECT THE POWER CORD FROM BOTH THE
Nº326S AND THE ELECTRICAL OUTLET BEFORE
INSTALLING THE PHONO MODULES.
Before installing the phono modules:
• Power off the Nº326S and all associated components.
• Disconnect the power cord from the ~ac input connector
AND the electrical outlet.
• Disconnect the Nº326S from all associated components.
To Next Page
Loading...
