To adjust the Bal parameter:
1. Rotate the front panel select knob or press the remote control
select ± buttons to select the phono input.
• The front panel display indicates the name and volume
level of the selected input.
2. Press and hold the front panel or remote control setup button
until the Name parameter appears on the front panel display.
• The front panel setup LED lights red to indicate that the
setup menu is open.
3. Rotate the select knob or press the select ± buttons until the
Bal parameter appears on the front panel display as shown.
4. Press the front panel or remote control enter button to select
the Bal parameter.
• The equal sign between the parameter name and the
parameter setting will blink to indicate that the Bal
parameter is selected.
5. Rotate the front panel volume knob or press the remote
control volume ± buttons to make balance adjustments:
• Rotate the volume knob clockwise or press the volume +
button to decrease the level of the left channel and
increase the right-channel level. The Bal parameter indi-
cates that balance is offset in favor of the right channel.
• Rotate the volume knob counterclockwise or press the
volume – button to decrease the input level of the right
channel and increase the left-channel level. The Bal
parameter appears as shown to the left to indicate that
balance is offset in favor of the left channel.
• Select the 0.0 setting to balance the input levels of the left
and right channels. The Bal parameter appears as shown
to the left to indicate that balance is centered between the
left and right channels.
6. When the desired setting appears on the front panel display,
press the enter button to select this setting.
7. Press and release the setup button to close the setup menu.
• The front panel setup LED is not lit when the setup
menu is closed.
14
Installation Instructions & Release Notes Mark Levinson
Bal= <-0.0->
Bal= <-0.0->
Bal= <---6.0
Bal= 6.0--->
PHONO (7)
Name= PHONO
To Next Page
Loading...
