Mark Levinson 536 - Page 14

14
N
0
536 MONAURAL / N
0
534 DUAL-MONAURAL AMPLIFIER / OWNER’S MANUAL
SPECIFICATIONS
№ 536 MONAURAL AMPLIFIER
Input & Output Connectors
• one balanced XLR input
• one unbalanced RCA input
• two pairs of “Hurricane” loudspeaker outputs with banana-
plug sockets per channel (banana-plug socket not available on
European models)
Control Connectors
• one Ethernet 10/100 port
• one 3.5mm mono (tip/sleeve) mini plug trigger input, 3-12Vdc
• one 3.5mm mono (tip/sleeve) mini plug trigger output, 3-12Vdc
• 3-pin IEC standard power connector
Rated Output Power
400W
RMS
at 8 ohms, 20Hz to 20kHz, at <0.3% THD
Frequency Response
10Hz to 20kHz +0/-0.2dB
Signal-to-Noise Ratio
>85dB, reference level: 2.83V
RMS
Input Impedance
60kΩ (balanced); 30kΩ (unbalanced)
Voltage Gain
26dB
Input Sensitivity
2.83V
RMS
output at 142mV
RMS
input
Power Requirements
100V~, 120V~, 230V~, factory set for destination country, 1,500W
Power Consumption
On, idle: 350W
Normal Standby: 65W
Power Save Standby: 5W
Green Standby: <0.5W
Dimensions
Height (with feet): 7.75” (19.7cm)
Height (without feet): 6.90” (17.5cm)
Width: 17.25” (43.8cm)
Depth: 20.97” (53.3cm)
Weight
Net weight: 100lbs (45.4kg)
Shipping weight: 117lbs (53kg)
SPECIFICATIONS