Marksa CSO Series - 9.14 Programmable Logic Controller (Y) - Error Messages and Settings Table

Technical Notice CSO/CPO V1.1 / 10.14 Page 73 / 86
Options 9
9.1.14.7 List of error messages (variable)
In the event of a fault, a red indicator lights up on the
unit.
When the red indicator light is on, the display shows the
explanation in 3 languages.
In the event of a breakdown, the fault that caused the
problem is shown and remains shown on the screen.
Example messages: non-exhaustive list, dependent
on the options purchased by the customer.
Fig. 9-23 : Example messages