marposs Quick Digit - Page 15

25/10/17
Quick Digit
TM
Bluetooth
®
Driver
15
3.6
CHAPTER 2
It should be noted that, if the Flow Control is programmed to execute Start Step when
the rst bit al (OR of all the instrument) changes state, the operator must press the
button corresponding to the Quick Digit
TM
Bluetooth
®
used in that step. If, on the other
hand, he/she presses the button associated with a different Quick Digit
TM
Bluetooth
®
,
the software would not receive the value via the correct channel, so that the channel
state would be indicated as “Not Ready”, and the contacts display would indicate the
message “Not yet acquired”.
The same message is displayed if the Flow Control takes more than 500 ms to
generate the Start Step command after the operator has pressed the button.
Use in Easy Acquisition
TM
This operating mode may be used only in the case of single acquisitions and if the
acquisition has been associated with the OR or all the instruments bit.