Route Inhibit Connector
The function of the route Inhibit Connector is to signal when specific exits, external to the
product, are in a “Full” condition. Signals from the machine ensure that, while the “Full”
condition continues, further coins/tokens directed to that exit will be re-routed to an
alternative exit. The instruction as to which alternative exits can be used will normally
come from the routing plug.
+ In order to inhibit a particular route, 0V must be applied to its respective pin.
+ An alternative route must always be of a lower priority
Lowest
0v0v9
Not definedNot defined8
BDivert route 77
DDivert route 66
CDivert route 55
(b)Divert route 44
(a)Divert route 33
To Next Page
Loading...
Need help?
General