MAINTENANCE
+ The practical maintenance that can be carried out is limited to cleaning the areas of the
validator that the coins travel through, and the replacement of the coin entry liner if it becomes
worn. All other servicing is carried out through your distributor.
The cleaning should be carried out on a regular basis of at least once a month, but, if you
have to visit the validator outside of that routine, it is worth while doing it then as well.
The shaded areas shown below, plus the back of the reject cover, are those to be cared
for.
The coin entry liner is accessed by unscrewing the coin entry moulding at the top of the
validator. The coin entry liner can then be eased off with the aid of a fine screwdriver, and
a replacement slid into place.
q Cleaning and maintenance must only be carried out by suitably trained personnel.
q Cleaning must only be carried out after power has been removed from the product.
q Never use a cleaner containing solvents, scrapers or abrasive materials.
q Never apply water or cleansers directly onto the product. Always apply them to a
clean cloth first, and not too liberally, so that the cloth used is only moist.
APPENDIX
24 ©, Mars, Inc., 1998
CashFlow
®
126 and CashFlow
®
129 selectors User Guide
To Next Page
Loading...
Need help?
General