INSTALLATION
Installing or removing the CashFlow
®®
product from your machine can be done by
following these simple instructions.
+ When installing the CashFlow
®®
126 Front Entry product it will be fitted to an MEI Front Plate and
the following instructions will always apply.
+ The mounting channel for the CashFlow
®®
126 top entry product is supplied by the machine
manufacturer, and therefore some variations may exist from machine to machine, however in
principle these instructions still apply.
CF126 Front Entry Installation
q Connect the separator loom to the connector at the base of the validator and locate
the rectangular boss on the top of the separator into the base of the validator.
q Firmly screw the separator fixing lugs onto the rear of the validator.
q Having ensured that the front plate has a firm location onto the front of the
machine, insert the side of the validator onto the two round bosses at the rear of
the front plate and push firmly together until the two retaining clips are fully
engaged.
6 ©, Mars, Inc., 1998
CashFlow
®
126 and CashFlow
®
129 selectors User Guide
To Next Page
Loading...
Need help?
General