Marshall Amplification VMV-402-SH - VMV-402-SH Static IP Address Configuration; Establish New VMV-402-SH Static IP Address

VMV-402-SH Manual
www.marshall-usa.com 14
9.9 Establishing a New Static IP address
To change the Static address to a custom Static address, from the Utilities tab, fi rst select IP Setting
then fi ll out the fi elds for the new IP Address, Subnet Mask and Gateway. Confi rm that DHCP Enable
is NOT checked then click the Apply button.
At this point, the VMV-402-SH will restart (indicated by all front panel buttons lighting). Close and
restart the control app. Allow at least one full minute before attempting to connect using the new
address using the method described above.
The new address will need to be manually entered in the Port Setting window
Note: The Factory Reset function does not change the IP address. In other words, the new address is
now the default address.